IES4005 Series

Thông tin chi tiết

System Specifications

DSL Compliant

ADSL:
- Support dual stack (IPv4 and IPv6)
- Auto or fixed operation as either one of the following: ADSL2, ADSL2+, G.dmt, T1.413, G.lite
- OAM loopback: both CO to CPE and CPE to CO
- Frequency allocation band plan 998 and 997
- 8 PVC per port
- G.992.1, G.992.3, G.992.5
- Latency path function in G.992.3 and G.992.5
- Annex L and Annex M in G.992.3 and G.992.5
- Loop diagnostic in G.992.3 and G.992.5
- Power management mode by TR-202
- Power management L0 and L2 mode. Parameters support: L0Time, L2Time,L2ATPR, L2ATPRT in G.992.3 and G.992.5
- Seamless Rate Adaptation (SRA: Fix rate, Startup, Runtime) on-line configuration in G.992.3 and G.992.5
- Reach extension ADSL (Annex L, RE-ADSL2)
- Loop Diagnostic Mode (LDM, DELT)
- Single End Loop Test (SELT)
- Double upstream (Annex M)
VDSL:
- Support dual stack (IPv4 and IPv6)
- IPv6
- VDSL2 profiles 8a, 8b, 8c, 8d, 12a, 12b and 17a
- 16 K MAC addresses
- 256 static MAC address filtering
- Port security—limited number of MAC addresses per port
- QoS support with IEEE 802.1P, 8 priority queues
- Port-based and tag-based (IEEE 802.1Q) VLAN for privacy
- IGMP proxy with snooping report
- MVR consolidates same video stream requests to one
- Configurable maximum nominal PSD mask
- Customer PSD
- RFI notch
- Single latency in PTM mode
- Loop Diagnostic Mode (LDM, DELT)
- Single End Loop Test (SELT)
- Seamless rate adaptation
- Power management mode under fallback operation: fixed, priority to ower, priority to rate
- Impulse noise protection

IPTV

512 IGMP groups
IGMP v3 any source multicast
IGMP group fast leave
IGMP message count control
MLD v2 any source multicast
IP multicast forwarding
Multicast VLAN (4 VLANs)
IGMP multicast channel limiting by count
IGMP multicast channel limiting by bandwidth usage
Multicast membership reports
Discard unknown multicast traffic
IGMP privilege profile
Broadcast/Multicast/Destination lookup fail storm control and configurable the limit number

VLAN

VLAN transparent (802.1D; except for VLAN stacking TLS mode in a port/PVC)
IEEE 802.1Q VLAN tagging
VLAN trunk
VLAN translation (8 rules per port/PVC)
VLAN aggregation (4 rules per port/PVC)
IEEE 802.1ad VLAN stacking (Outer TPID configurable, selective QinQ; VLAN stacking TLS mode can not coexist with VLAN transparent in a port/PVC)
Limited MAC per DSL port
At least 1024 VLAN ID
Able to accept untagged frame from CPE
IEEE 802.1p priority que; at least 8 per uplink
Protocol-based VLAN
Port isolation
Broadcast storm control

Security

DHCP spoofing with static IP filtering
Anti-MAC spoofing & ARP inspection (both can be enabled at the same time)
Upstream ACL mechanism: up to L4 packet classification based on IP source/destination address, protocol ID, UDP/TCP source/ destination port number and action definition
Static MAC address filtering by source/ destination
ARP broadcast filtering
DHCP broadcast filtering
NetBios filtering
IGMP filtering
BPDU filtering
L2 frame filtering, such as based on source MAC address, port etc.
PPPoE filtering
Layer 3 filtering based on IP header: source addresses, destination addresses, protocol ID, UDP/TCP port number
L2 frame filtering based on OUI
IPv6 packet classification
L2 filtering based on Ether type, source/ destination MAC address
Static MAC address forwarding/port lock
Anti MAC/IP address spoofing (DHCP snooping)
Limitation of number of dynamic learned MAC address on per subscriber port
Ethernet MAC filtering

Traffic Management

IEEE 802.3ad (link aggregation; LACP, GE uplink only)
IEEE 802.1d (Spanning tree)
IEEE 802.1w (Rapid spanning tree protocol)
PPPoE
PPPoEIA
DHCP (Snooping, relay & option 82)
LAN to LAN (Transprent LAN service; TLS)
IEEE 802.1p priority que
- Configurable based Strict Priority Queuing (SPQ) or Weighted Round Robin (WRR)
- DSCP code to 802.1p priority mapping
PVC default priority
OAM F5 loopback
Performance counters
Performance statistics (15 m)
DHCPv6 L2 relay agent
Support dual stack (IPv4 and IPv6)
MTU size up to 1600
Rate limiting
Upstream broadcast storm control

VoIP

ITU-T H.248 v2 or RFC3261 SIP v2
Codec: G.711 (μ-law and A-law), G.726, G.729a/b, G.723.1
RTP (RFC1889)
RTCP (RFC1890)
RTP payload for DTMF digits (RFC2833)
Echo cancellation and auto gain control (G.165, G.168)
Voice Activity Detection (VAD)
Comfort Noise Generation (CNG)
Caller ID generation
Metallic Loop Testing for subscriber lines (MLT)
Configurable jitter buffer
Certified POTS phone with individual country code signaling
Certified Fax machine with T.30, T.38
Certified analog dial-up modem
Certified pay phone with battery (polarity) reversal, 12 KHz or 16 KHz charging signal
Certified POS terminal
Dial tone, second dial tone, ringing tone (ringback tone), busy tone, off-hook, warning tone Supplementary services
Emergency call local route
Do not disturb
Selective/anonymous call rejection
Call waiting and call hold
Call transfer (blind and attended transfer)
Call return and call back on busy
Off hook warning tone
Warning tone
Calling Line Identification Presentation (CLIP)
Calling Line Identification Restriction (CLIR)
Abbreviated dialing (speed dial)
Hotline (H.248)
Local dial (SIP only)

Network Management

DDMI readout for each uplink port (SFP dependent)
FTP for firmware upgrade, via MSC or via console
Dual image for smooth FW upgrade
Text-base configuration through console port and telnet (CLI)
Daylight saving
Configurable TPID
ZyXEL private MIB
RFC1213 MIB II Management Information Base for Network Management of TCP/IPbased internets
RFC5650 VDSL2 line MIB

Hardware Specifications

IES4005M

Four slots for hot-swappable line cards
One slot for hot-swappable management & uplink card
One slot for DC or AC power module
One slot for hot-swappable FAN module
2G backplane switching capacity per line card slot
2U in height
Rack-mountable for 19-inch and 21-inch rack
Front access (all interface, including all line cards, power and FAN modules)
REN: 15
Grounding terminal

Management Switch Cards—MSC1002G

Two 1G SFP open slots
DDM readout
1G switching capacity to each line card slot
Independent LED to indicate the following status:
- System status (SYS)
- Power status (PWR)
- Alarm status (ALM)
- Individual link status (LINK)
- Individual traffic status (ACT)
Hot-swappable

ADSL Line Card—ALC1132G-51

Thirty-two ADSL+POTS subscriber ports via one champ-64 connector
Thirty-two POTS splitter input ports via one champ-64 connector
Annex A
Built-in POTS splitter that supports both 600 and 900 ohm
Independent LED to indicate the following status:
- Power status (PWR)
- Alarm status (ALM)
Hot-swappable

VDSL Line Card—VLC1132G-51

G.993.2, G.994.1, G.997.1
Thirty-two VDSL+POTS subscriber ports via one champ-64 connector
Thirty-two POTS splitter input ports via one champ-64 connector
Annex A
Built-in POTS splitter that supports both 600 and 900 ohm
Independent LED to indicate the following status:
- Power status (PWR)
- Alarm status (ALM)
Hot-swappable

VoIP Line Card—VOP1164G-61

Sixty-four voice subscriber ports via two champ-64 connectors
Independent LED to indicate the following status
- Power status (PWR)
- Alarm status (ALM)
Hot-swappable
Loop current:
- 25 mA MAX
- ≥20 mA at 800 ohm loop resistance

GPON SFP Type ONT— PMG3000-D20A

One GPON WAN port with SC/APC connector
Class B+ optics
Complies with ITU-T G.984.1, G.984.2, G.984.3,G.984.4 and G.984.5 standards
One SFP Electrical Footprint complies MSA
Single fiber BiDi SC/APC receptacle
Ethernet IEEE 802.1q/p VLAN and priority
IEEE 802.3x flow control

Physical Specifications

IES4005M

Item dimensions (WxDxH): 440 x 270 x 88 mm (17.32″ x 10.63″ x 3.46″)
Item weight: 5.124 kg (11.32 lb.)
Packing dimensions (WxDxH): 530 x 372 x 186 mm (20.86″ x 14.64″ x 7.32″)
Packing weight: 6.28 kg (13.88 lb.)

Management Switch Card—MSC1002G

Item dimensions (WxDxH): 130 x 223 x 42 mm (5.12″ x 8.78″ x 1.65″)
Item weight: 0.515 kg (1.14 lb.)
Packing dimensions (WxDxH): 185 x 329 x 78 mm (7.28″ x 12.95″ x 3.07″)
Packing weight: 0.741 kg (1.64 lb.)

ADSL Line Card—ALC1132G-51

Item dimensions (WxDxH): 260 x 228 x 16 mm (10.23″ x 8.97″ x 0.63″)
Item weight: 0.701 kg (1.55 lb.)
Packing dimensions (WxDxH): 375 x 295 x 53 mm (14.76″ x 11.61″ x 2.09″)
Packing weight: 0.968 kg (2.14 lb.)

VDSL Line Card—VLC1132G-51

Item dimensions (WxDxH): 260 x 228 x 16 mm (10.23″ x 8.97″ x 0.63″)
Item weight: 0.765 kg (1.67 lb.)
Packing dimensions (WxDxH): 375 x 295 x 53 mm (14.76″ x 11.61″ x 2.09″)
Packing weight: 1.022 kg (2.26 lb.)

VoIP Line Card—VOP1164G-61

Item dimensions (WxDxH): 260 x 228 x 16 mm (10.23″ x 8.97″ x 0.63″)
Item weight: 0.938 kg (1.67 lb.)
Packing dimensions (WxDxH): 375 x 295 x 53 mm (14.76″ x 11.61″ x 2.09″)
Packing weight: 1.202 kg (2.26 lb.)

GPON SFP Type ONT—PMG3000-D20A

Item dimensions (WxDxH): 14 x 75 x 13 mm (0.55″ x 0.24″ x 0.04″)
Item weight: 29.9 g (0.06 lb.)
Packing dimensions (WxDxH): 49 x 115 x 24 mm (0.16″ x 0.37″ x 0.07″)
Packing weight: 39.4 g (0.08 lb.)

Environmental Specifications

Operating environment:
- Temperature: -40°C to 65°C (-40°F to 149°F)
- Humidity: 10 to 95% (Non-condensing)
Storage environment:
- Temperature: -40°C to 70°C (-40°F to 158°F)
- Humidity: 10 to 95% (Non-condensing)
Full load power consumption:
- MSC1002G: 37 W
- ALC1132G-51: 33.5 W
- VLC1132G-51: 39.2 W
- VOP1164G-61: 91.7 W
- IES4005M-FAN: 19 W

Certification

RoHS & WEEE compliant
2011/65/EU (RoHS 2) Restriction of Hazardous substances Directive
2012/19/EU (WEEE 2) Waste electrical and electronic equipment Directive
94/62/EC (PPW) Packaging and packaging waste Directive
1907/2006 (REACH) Registration, evaluation, authorization and restriction of chemicals Regulation
ZyXEL ZA 3023—Environmental hazardous substances controlled standardization procedure requirement
ETSI 300-019
ITU-T K.20